Wall to wall carpeting – Blanket is pulled out of the neck strip during a remodel will be necessary to re-stretched and then re-nailed to secure it to the floor. Re-nailing, the process of attaching the carpet to the rate stripe that is nailed to the perimeter of a room. You need an effective stretcher to re-stretch the carpet until it is re-nailed to the floor or attached price strip.
How to renail wall to wall carpeting, pull up the corner of the blanket and pillow from the wall using a rod. Grab the corner of the blanket with his hands, and pull it out to the rest of the tack strips. Remove all tack strips, if necessary with a hammer or pry bar. Insert pry bar at the bottom of the neck tape, and beat it with the hammer to force it below. Push down on the crowbar to force the rate strips off the floor. Install a new course stripe by putting the neck band. Secure it by running pre-set nail in the floor.
12 Picture Gallery: How to Renail Wall to Wall Carpeting
Place the power stretcher on the floor and shine one end against the opposite wall, where you need to attach the carpet. Put your head on the stretcher about six inches from the end of the carpet you have to link to the parity strips. Pull the handle on the power stretcher down to stretch the carpet. Place the end of the carpet on the tack strip. Use your hand or a stair chisel to ensure the wall to wall carpeting at a price strip.
This post topic: Carpet Design